Article: ROKR Romantic Note Wall Clock 3D Wooden Puzzle LC701 Troubleshooting & FAQ

ROKR Romantic Note Wall Clock 3D Wooden Puzzle LC701 Troubleshooting & FAQ

26 août 2026 2 min de lectureRobotime

ROKR Romantic Note wooden wall clock LC701 mounted on a white wall with copper pendulum hanging below

Product: ROKR Romantic Note Wall Clock 3D Wooden Puzzle
SKU: LC701
Product type: 3D Wooden Clock Puzzle

Quick answer: This guide provides the LC701 parts reference and the official checks for clock-weight setup, thread winding, ratchet direction, pendulum movement, escapement parts, clock-weight requirements, and gear assembly. For the full manual and assembly resources, visit Assembly Guides and Manuals. For missing, broken, uncut, or visibly warped parts, use Part Replacement.

Parts Reference

Use this diagram to identify the LC701 P part before and during assembly.

ROKR Romantic Note Wall Clock LC701 parts list — LC701 P part list reference.

Functional Problems

Clock Weight Setup Check

Pull the clock weight straight to the bottom.

① Check whether the thread has been wound three times.

ROKR Romantic Note Wall Clock LC701 thread winding reference — LC701 thread wound three times.

② Check the assembly direction of the ratchet.

ROKR Romantic Note Wall Clock LC701 ratchet assembly direction reference — LC701 ratchet assembly-direction reference.

Why Can't the Clock or Pendulum Operate Normally?

① Check for interference with the pendulum and make sure there is no friction at the front or back of the pendulum. Adjust it using the rotatable wooden plate and the hand screw. Also tighten the screws connected to the pendulum.

② In Step 3 on page 9, wind the black thread three times. Too many or too few windings will affect rotation. The clock weight descending too quickly or not descending at all can also result from an incorrect number of windings.

③ Refer to the small picture at the top of page 21 to adjust the rotatable wooden plate. Then check whether escapement fork C3 was assembled in reverse, and apply more wax to escapement fork C3 and escapement wheel A10 according to the instructions.

④ Check whether the clock weight meets the weight requirement. A weight of 300 g is sufficient for swinging when the model is assembled correctly. You can add weight as appropriate or apply more wax between the gears.

⑤ Check whether the gears are assembled correctly.